53
If the camera fails automatically to connect a PC or a printer using a
USB cable, you can manually set [Computer] or [Printer].
-[USB] sub menus:
[Auto]* : Automatically enables an
external device connected
with a USB cable.
[Computer] :
Sets computer connection
mode if the connected external
device cannot be recognized
automatically.
[Printer] : Sets printer connection mode if the connected
external device cannot be recognized automatically.
You can turn on and off the Auto Focus lamp.
- Sub menus
[Off] : The AF lamp will not light up in
low light conditions.
[On]*
: The AF lamp will light up in low
light conditions.
Auto Focus lamp
Settings
(
”
)
Setting the USB
Back Set
AF Lamp :On
USB :Auto
Video Out :NTSC
Off
On
Back Set
AF Lamp :On
USB :Auto
Video Out :NTSC
Auto
Computer
Printer
To Next Page
