Samsung FH052EAV1 - Setting Option Setup Method

Samsung Electronics
The default value is .
Otherwise, push the button to
.
Every time you push the button, the display panel reads or
repeatedly.
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
➡ ➡
➡ ➡. . .  ➡ ➡ ➡ ➡ ➡ ➡ repeatedly.
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
➡ ➡
➡ ➡. . .  ➡ ➡ ➡ ➡ ➡ ➡ repeatedly.
Push the button to set the display panel to .
Every time you push the button, the display panel reads
➡ ➡
➡ ➡. . .  ➡ ➡ ➡ ➡ ➡ ➡ repeatedly.
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
➡ ➡
➡ ➡. . .  ➡ ➡ ➡ ➡ ➡ ➡ repeatedly.
Push the button to set the display panel to
.
Every time you push the button, the display panel reads
➡ ➡
➡ ➡. . .  ➡ ➡ ➡ ➡ ➡ ➡ repeatedly.
3-3 Setting Option Setup Method
Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously and
insert the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
1
S Setting is not required if you must
a value which has a default.
2
3
4
5
6
1
2
3
4
5
6
3-3-1 Type A (Setting Option)
3-5