E-11
HSILGNE
Adjusting the Air Flow Direction
Operating Recommendations
Here are a few recommendations that you should follow when operating
your
air conditioner.
Topic Recommendation
The heat pump function of the air conditioner absorbs heat
fro
m
outside air and brings it indoors. As the temperature of the
outsid
e
air drops, the heating performance of air conditioner will
decrease.
If you find that the room is not warm enough, using
an
additional heating appliance is recommended.
Heating
performances
When outside temperature is low but humidity is high,
frost
may form on the outdoor unit at HEAT mode.
If this happens:
The heating operation stops.
The defrost mode will be triggered automatically for 3 to
14
minutes.
No intervention is required ; after about 7 minutes, the air
conditioner operates again normally.
Frost
If both indoor and outdoor temperatures are high and the air
conditioner
is running at HEAT mode, the outdoor unit’s fan
and
compressor may stop at times.
This
is normal ; simply wait until the air conditioner switches
on
again.
High
indoor
and
outdoor
temperatures
If a power failure occurs while the air conditioner is operating,
the
unit will be switched off. When the power returns, the air
conditioner
starts up again automatically.
Power failure
The indoor unit may not get the selected fan speed such as
Medium
and Low under cooling operation at very low outdoor
temperatures
for protecting the indoor unit from ice or frost.
During
Low fan speed operation, cooling performance will be
reduced.
If the room does not cool down when using Low fan
speed
operation, please adjust the indoor unit’s fan speed.
Cooling
operation
FH052EAV IB_E_23954 3/24/06 2:47 PM Page 11
There are two sets of inner air flow blades. Just as the outer air flow blade
can
be adjusted vertically, the inner blades can be adjusted horizontally.
Adjust each set of inner blades to the required position, by pushing or
pulling
them sideways.
To Next Page
Loading...
