To prevent any fire accident or gas leakage caused by children, close
the middle valve when the product is not used.
Caution
Make sure that the ignition handle is on 'Extinguishment' position.
Turn on
Make sure that the power plug is inserted into the outlet.
Make sure that the firepower adjustor handle is on
'Extinguishment' position. Then, open the middle valve.
Turn the firepower adjustor handle clockwise to the
extinguishment position.
When the burner is extinguished, it may sound 'Puck',
which is the sound made when the flame is off and this
does not show any abnormality.
Right after extinguishment, the product is still hot. Be
careful not to be burned.
Close the middle valve.
Pressing the firepower adjustor handle, turn it toward the ignition
(counterclockwise)
direction completely. If you release the handle while turning, the
product will not be ignited.
Release the handle after confirming that the product has been
ignited.
-4 burners will all discharge electricity but only the burner for
ignition will be ignited.
-If not ignited, turn the firepower adjustor handle to the
extinguishment position and then ignite again.
-If not used for a long time, the product will not be well ignited
because the gas tube has full of air.
Preparation
Ignition
Adjust the flame by slowly turning the firepower adjustor handle
within the range between the extinguishment and ignition.
If the flame is extremely reduced or adjusted too fast, it may be
extinguished. Becareful.
Firepower Adjustment
Extinguishment
Turn the handle as shown by the arrow.
The figure shows the closing status of the middle valve.
Closing Status of Middle Valve
Turn off
Must Do
Must Do
Must Do
Must Do
Prohibited
Open Status of Middle Valve
To Next Page
Loading...
