Read this section carefully for correct maintenance!
1.Surface of the Product
2.Top Plate of the Product
Wipe it well with a soft cloth.
Wiping it with any metal or nylon brush may damage it.
3.Burner Part
Wipe overflowed part with neutral detergent
and dry it fully.
Alkali detergent may damage the coated face of product.
Maintain and clean the product wearing gloves.
Usable Unusable
Soft Cloth
Acidic/Alkali
Detergent
Abrasive
Thinner/Benzene
Sponge Brush
Neutral
Detergent
Edible Oil
Nylon Brush Metal Brush
Caution
Dried and attached overflow-substance may be too sticky to be
wiped out. Wipe the product right after using.
If too much contaminated, wipe the product using a dried towel with
a neutral detergent, and then wipe it again using a dried cloth.
If you wipe the top plate with a metal brush, it will be damaged.
Clean it wearing gloves.
Clean the flame hole of the burner from time to time. If the
burner is contaminated, tis flame hole is clogged making
incomplete ingition.
Take off the burner head. Clean the upper circumference of the
burner body and burner head using a harsh brush. Use a drill for
cleaning of the flame holes.
If the flame holes are not drilled or the burner head has become
thinned down due to a long period of use, replace it with new one
and keep it clean all the time.
After cleaning, dry the parts completely or assemble them to their
original positions. If the ignition plug or its ambient part is wet,
electricity is not normally discharged.
The safety device for automatic block of gas should be cleaned
without any hard brush and etc. If any soup is flown over, wipe it out
immediately. Otherwise, the product performance will decline and its
life will be reduced as well.
To Next Page
Loading...
