Samsung HG32EC690 - Page 60

60
English
¦ Sound Bar
• Samsung Sound-Bar & Hospitality TV
– Use Samsung Sound-Bar & hospitality TV support HDMI 1.4 to listen to TV sound on the Sound-Bar by using a
single HDMI cable.
– Supporting model.
• Sound-Bar : HW-F350/F450/F550
• Operation of “Hotel Mode” in Sound Bar
– The following items for the TV’s hotel option menus should be set in advance.
• Hotel option → Power On → Power ON Volume = "Enable" / Power ON Vol / Max Vol
• Hotel option → External Device → Sound Bar Out = "On"
• Connect an HDMI cable from the HDMI OUT port of Sound-BAR to the HDMI2 port of hospitality TV.
• After being connected to the 2013 hospitality TV via HDMI Cable, when the TV turns on, the Sound-Bar
automatically detects the TV and then, converts to “hotel mode” by itself.
• The change with power-on volume & max volume on TV is applied to the connected sound-bar since TV
boots twice.
• Features of "Hotel Mode" in Sound Bar
– Synchronized power on/off with TV.
– HDMI_CEC enabled.
– Accessible “HDMI OUT” port only. (Other inputs are disabled)
– Synchronizing “power-on”&“max” volume with the TV the Sound-Bar’s volume is set at half of the TV.
– Adjustable “power-on”&“max” volume acquired from the TV’s hotel option menu. Sound-Bar volume=TV
volume/2
– Example: If the volume settings in TV are “power-on volume=20 and max volume=90”, the sound bar will
operates at volume=10, max volume=45.
*This function may differ depending on the model.
¦ Security mode
Design Specifications
• This is to restrict some functions such as TTX and external source (HDMI, USB) input in specific facilities such as
a correctional facility.
• The Security menu is password-protected. Access to the Security menu is denied without the password.
• Security Setting
– The Security Setting can be set to ONor OFF.
– The default is OFF.
– Security Setting: If set to On, external source (HDMI, USB) input and the TTX function will be disabled.
• Password Setting
– This allows users to change the password.
– Users must input the current password, a new password, and confirmation of the new password.
• Password Reset
– This is to reset the password.
– The default password is "00000000".
– Password Reset is visible
only in the Factory menu by using the key combination of Info and Factory.
It is not visible using the key combination of MUTE + 1 + 1 + 9 + ENTER.
• Security Setting: If set to On, the SIRCH function is not available.
• Factory Reset will not reset the Security Setting.
[HC690-EUROPE]Install Guide-X0ENG.indd 60 2014-04-08  11:20:54