y
holding them for 10 seconds. When all LEDs blink 5 times, the factory restore is complete.
y The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room.
The LEDs that were turned off will turn on again if the guest touches any of the buttons, and the 5-minute timer
will restart. If the guest then touches another source button, the TV will change to the selected source and the
corresponding LED will be illuminated.
y
the RJP.
y The following table shows the approximate time in seconds to switch from the TV to the input source, based on the
priority.
✎
Source To Connect
2 Sec
PC 0.7 Sec
HDMI
✎
Source Disconnect To Connect Total
4.5 Sec 2 Sec 6.5 Sec
PC 0.7 Sec 0.7 Sec 1.4 Sec
HDMI
✎
seconds.
y
y
To Next Page
Loading...
