Cloning
USB Cloning is a function that allows you to download user configured settings (Picture,
Sound, Input, Channel, Setup, and Hotel Setup) from one TV set and upload the same
settings to other TV sets.
USB Cloning support 2.0 Standard only.
y Clone TV to USB
of the TV EEPROM to the USB device.
1. Insert a USB drive into the USB port on the back of the TV.
2. Enter the Hotel Options by pressing these buttons in the following order:
MUTE → 1 → 1 → 9 → ENTER
3. Press the ▲ or ▼ button to select “Clone TV to USB”, then press the ENTER button.
4. The message “Clone TV to USB” is displayed; press the ENTER button.
5.
y In Progress: While copying data to the USB device.
y Completed: The copy operation was successfully completed.
y Failed: The copy operation was not successfully completed.
y No USB: No USB device connected.
y Clone USB to TV: This is an operation that uploads the data from a USB device to the
TV set.
1. Insert a USB drive into the USB port at the back of the TV.
2. Enter the Hotel Options by pressing these buttons in the following order:
MUTE → 1 → 1 → 9 → ENTER
3. Press the ▲ or ▼ button to select “Clone USB to TV”, then press the ENTER button.
4. The message “Clone USB to TV” is displayed, then press the ENTER button.
5.
y In Progress: Copying data to the USB device.
y Completed: The copy operation was successfully completed.
y Failed: The copy operation was not successfully completed.
y No USB: No USB device connected.
y No File
✎ ENTER key for 5
seconds.
✎ The CLONE function only supports the same model series. (It does not work for
different model series.)
(ARC)
(5V 0.5A)
/ CLONING
To Next Page
Loading...
