Connecting the TV to a SBB or STB
ETH MODEM
TV Rear Panel
STB (SBB)
Connect the DATA port of the TV to the ETH MODEM
The ETH MODEM
IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal receiver specification
– Band pass filter centre frequency: ㎑
–
–
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
List of Hospitality SI Vendors and compatible data cables supplied with the TV
Confirm you are using the correct data cable for your SI vendor. Refer to the code label on the data cables.
Contact your nearest dealer or your SI Vendor to buy the data cable not included in the TV.
1
6
1
2
3
4
5
TV side STB (SBB) side
Cable code Pin assign SI Vendor
TV SIDE
1: TX
2: RX
3: IR
4: NC
5: GND
STB (SBB) SIDEP1 P2
31
52
63
14
25
1: NC
2: GND
3: TX
4: NC
5: RX
6: IR
RED
GREEN
WHITE
BLACK
YELLOW
SAMSUNG and
others
RX and TX notation is based on TV.
English - 25
To Next Page
Loading...
