EasyManuals Logo

Samsung HT-C5500D User Manual

Samsung HT-C5500D
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
20 English
Connections
NOTE
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too
close to the product, some sound interruption may be heard due to interference.
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other
device that uses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard
due to interference.
The transmission distance from the product to the wireless receiver module is about 10m, but may vary
depending on your operating environment. If a steel-concrete wall or metallic wall is between the product
and the wireless receiver module, the system may not operate at all, because the radio wave cannot
penetrate metal.
If the product doesn't make wireless connection, the product needs ID Setting between the product and
wireless receiver module. With the product turned off, press remote control's number buttons
"0""1""3""5" and turn on the product. With the wireless receiver module turned on, press "ID SET"
button on the back of the wireless receiver module for 5 seconds.
CAUTION
Do not insert any other card except the provided TX card.
If a different TX card is used, the product may be damaged or the card may not be removed easily.
Do not insert the TX card upside down or in the reverse direction.
Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a
problem.
If the TX Card is inserted and wireless receiver module setting is complete, sound is not output from the
surround speaker connectors on the product.
The wireless receiver antenna is built into the wireless receiver module. Keep it away from water and
moisture.
For optimal listening performance, make sure that the area around the wireless receiver module location is
clear of any obstructions.
If no sound is heard from the wireless receiver module, switch the mode to DVD 5.1 channel or
Dolby ProLogic II .
In 2-CH mode, no sound will be heard from the wireless receiver module.
!
HT-C5500D_ELS_ENG_0318.indd 20HT-C5500D_ELS_ENG_0318.indd 20 2010-03-18  5:21:092010-03-18  5:21:09

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Samsung HT-C5500D and is the answer not in the manual?

Samsung HT-C5500D Specifications

General IconGeneral
BrandSamsung
ModelHT-C5500D
CategoryHome Theater System
LanguageEnglish

Related product manuals