20 English
Connections
HDMI IN :
Connecting to an External Component with an HDMI Cable
Connect an HDMI cable
(not supplied)
from the HDMI IN jack on the back of the product to the HDMI OUT
jack on your digital devices.
Press the FUNCTION button to select HDMI 1 or HDMI 2 input.
The mode switches as follows :
BD/DVD D. IN AUX HDMI 1 HDMI 2 FM
HDMI Auto Detection Function
The product's video output will automatically change to HDMI mode when connecting an HDMI cable
before power is on. For possible HDMI resolutions, see page 28.
This function is not available if the HDMI cable does not support CEC.
HDMI connection description
- HDMI outputs only a pure digital signal to the TV.
- If your TV does not support HDCP, random noise appears on the screen.
What is the HDCP?
HDCP (High-band width Digital Content Protection) is a system for protecting BD/DVD content outputted via
HDMI from being copied. It provides a secure digital link between a video source (PC, DVD. etc) and a display
device (TV, projector. etc). Content is encrypted at the source device to prevent unauthorized copies from being
made.
CAUTION
The Anynet+ function is supported only when an HDMI Cable is connected to the HDMI OUT of the
product.
1.
2.
•
•
•
!
Connecting the FM Antenna
Connect the FM antenna supplied to the FM
75Ω COAXIAL Jack.
Slowly move the antenna wire around until you
fi nd a location where reception is good, then
fasten it to a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎
DIGITAL
AUDIO IN
FM ANT.
iPod
OPTICAL
DIGITAL
AUDIO IN
o
FM Antenna (supplied)
HT-C6200_ELS_ENG_0228.indd 20HT-C6200_ELS_ENG_0228.indd 20 2010-03-02 5:34:352010-03-02 5:34:35
To Next Page
Loading...
