Samsung HT-D6530 - Speaker Components; Installing the Speakers on the Tallboy Stand

20 English
Connections
Speaker Components Assembled Speakers
FRONT
(L) (R)
SURROUND
(L) (R)
CENTRE
STAND
STAND BASE
SUBWOOFER
SPEAKER
CABLE
¨
CENTRE SPEAKER
SURROUND
SPEAKER
SUBWOOFER
FRONT
SPEAKER
SCREW (5X15): 2EA
SCREW (4X20): 8EA
Installing the Speakers on the Tallboy Stand
Turn the Stand Base upside-down and connect it to
the Stand.
Insert small screws (4x20, For connecting Stand &
Stand Base) clockwise into the four holes marked
using a screwdriver as shown in the illustration.
CAUTION
When you use a torque screwdriver, be careful not
to put excessive force. Otherwise, it runs idle or
can be damaged. (torque screwdriver- below 15
kg.f.cm)
Connect the upper Speaker to the assembled
Stand.
Insert another large screw (5x15, For connecting
Speaker & Stand) clockwise into the hole on the rear
of the speaker using a screwdriver.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
1.
2.
!

3.
4.
5.
4
2
Stand
Stand
Base
1
3
Stand
Speaker
5
HT-D6530_XAC_0302.indd 20HT-D6530_XAC_0302.indd 20 2011-03-02 ¿ÀÈÄ 2:27:492011-03-02 ¿ÀÈÄ 2:27:49