Display
Function
LINK
(Blue LED)
STANDBY
(Red LED)
LED ON
Pairing
successfully
completed
STANDBY
LED BLINK
(Long blink)
Processing iPod/
iPhone
LOW BATTERY
LED BLINK
(Short blink)
Processing
pairing
Pairing failed
CAUTION
If you use the main unit near a wireless device
such as a laptop computer, an AP, or Wifi , an
unstable operation error can occur.
The transmission distance from the product to
the wireless transmitter is about 5 meters, but
may vary depending on your operation
environment.
The audio signal may be weakened or even
lost where there is an obstacle such as a wall
or partition between the product and wireless
transmitter. You can also weaken or lose signal
if you move the wireless transmitter around.
!
How to Link the Wireless Transmitter
with the Main Unit
Turn off your Home Cinema.
Press the 4, 7, 6, 3 buttons on the remote
control in order.
The Power LED blinks once.
Connect the iPod/iPhone to the Wireless
transmitter.
S
T
A
N
D
B
Y
L
IN
K
C
H
A
R
G
E
Turn on the iPod/iPhone. Press the "ID SET"
button on the back of the Wireless
transmitter for 5 seconds. The link light on
the wireless transmitter blinks rapidly.
Turn on your product.
To listen to music from iPod/iPhone over the
product, press the button to select
"W. IPOD" mode.
After you select "W. IPOD" mode, turn the
volume of the product down to avoid hearing
damage.
You can control the speaker volume of iPod/
iPhone with a volume wheel or a volume bar.
When iPod/iPhone is stopped or in a power
saving mode, the Wireless transmitter enters
Sleep Mode.
When iPod/iPhone is set to Deep Sleep
Mode, the Wireless transmitter turns off.
1.
2.
•
3.
4.
5.
•
•
•
•
HT-D7100_ELS_1227.indd 56HT-D7100_ELS_1227.indd 56 2011-12-27 1:19:362011-12-27 1:19:36
To Next Page
Loading...
