Samsung HW-MS6500 - Page 22

What are the BT READY and BT PAIRING statuses?
• BT READY: In this mode, you can search for previously connected TVs or connect to the Sound bar
from a previously connected mobile device.
• BT PAIRING: In this mode, you can connect to a new device. (While in ltBT' mode, press and hold the
~(Source) button for more than 5 seconds on the right side of the Sound bar or on the remote
control.)
NOTES
• If asked for a PIN code when connecting a Bluetooth device, enter <0000>.
• In Bluetooth connection mode, the Bluetooth connection will be lost if the distance between the
Sound bar and the Bluetooth device exceeds 32.8 ft.
•
The Sound bar automatically turns off after 5 minutes in the Ready state.
•
The Sound bar may not perform Bluetooth search or connection correctly under the following
circumstances:
- If there
is a strong electrical field around the Sound bar.
- If several Bluetooth devices are simultaneously paired with the Sound bar.
- If the Bluetooth device is turned off, not in place, or malfunctions.
• Electronic
devices may cause radio interference. Devices that generate electromagnetic waves
must be kept away from the Sound bar main unit- e.g., microwaves, wireless LAN devices, etc.
Disconnecting the Sound bar from the Bluetooth device
Press the~ (Source) button on the right side panel or on the remote control, and then change to any
mode except ltBT
1
•
• Disconnecting takes time because the Bluetooth device must receive a response from the
Sound bar. (Disconnection time may differ, depending on the Bluetooth device)
• When the Sound bar is disconnected from the Bluetooth device, the Sound bar will display
ltBT DISCONNECTED)) on the front display.
ENG -16