Samsung HW-MS6500 - Mounting and Cable Management

2. Align the Paper Template's Center Line with
the center of your
TV (if you are mounting
the
Sound bar below your TV), and then fix
the
WaLL Mount Guide to the wall using tape.
lo
• If you are not mounting below a TV, place
the Center Line in the center of the
installation
area.
Centerline
3. Use a sharp object, such as a pen or pencil, to
mark the holes' positions,
and then remove
the
WaLL mount Guide.
0
4. Using an appropriately sized drill bit, drill a
hole in the wall at each marking.
• If the markings
do not correspond to the
positions of studs,
make sure you insert
appropriate anchors or mollies into the
holes before you insert the support
screws . If you use anchors or mollies,
make sure the holes you drill are large
enough for the anchors or mollies you
use.
5. Push a screw (not supplied) through each
Holder-Screw, and then screw each screw
firmly into a support screw
hole.
6. Install the 2 Bracket-WaLL Mounts in the
correct orientation
on the bottom of the
Sound bar, using 2 Screws.
• When assembling, make sure the hanger
part of the
Bracket-WaLL Mounts are
located behind the rear of the Sound bar.
RearofSoundbar
Right end of Sound bar
ENG - 24