《76》
Before contacting a service centre
The camera doesn’t switch on
ㆍThere is low battery capacity
→ Insert fresh batteries. (p.12)
ㆍBattery is inserted incorrectly with the polarities reversed.
→ Insert the battery according to the polarity marks (+, -)
The camera power ceases while in use
ㆍThe battery is exhausted
→ Insert fresh batteries
ㆍThe Camera is turned off automatically
→ Turn on the camera power again.
Battery power quickly drains
ㆍThe Camera is being used in low temperatures
→ Keep the camera in warm conditions (i.e. inside a coat or jacket) and only
remove it in order to take images
■ Please check the following
Camera does not take images when pressing the Shutter button
ㆍThere is insufficient memory capacity
→ Delete unnecessary image files
ㆍThe memory card has not been formatted
→ Format the memory card (p.48)
ㆍThe memory card is exhausted
→ Insert a new memory card
ㆍThe memory card is locked
→ Refer to [Card Locked!] error message
ㆍThe camera’s power is off
→ Turn the camera power on
ㆍThe battery is exhausted
→ Insert fresh batteries (p.12)
ㆍBattery is inserted incorrectly with the polarities reversed.
→ Insert the battery according to the polarity marks (+, -)
The camera suddenly stops working while in use
ㆍThe camera stopped due to a malfunction
→ Remove /re-insert battery and switch the camera on
The images are unclear
ㆍA picture was taken the subject without setting an appropriate macro mode
→ Select an appropriate macro mode to take a clear image.
ㆍTaking a picture beyond the flash range
→ Take a picture within the flash range
ㆍThe lens is smudged or dirty
→ Clean the lens
To Next Page
