19
Installation
Attaching the Stand
21
5
3
4
Insert the stand neck into the stand base in the
direction shown in the ѣgure.
Check that the stand neck is ѣrmly connected. Tightly fasten the connecting screw at the bottom
of the stand base.
- Caution
Do not press down on the monitor. There is a risk
of damaging the monitor.
Take out the two parts of the stand-the
connection part and the base-out of the
package.
Fasten the connection part onto the screen
with two screws.
6
Hold the main body of the product with your hand
as shown by the ѣgure. Push the assembled stand
into the main body in the direction of the arrow as
shown in the ѣgure.
ࣖ
Before assembling the product, place the product down on a Ѥat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a Ѥat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
ࣖ
The exterior may differ depending on the product.
To Next Page
Loading...
