English-15
Turning the TV On and Off
Press the POWER button on the remote control.
You can also use the button on the front of the panel.
Plug & Play Feature
When the TV is initially powered on, two basic settings proceed automatically and subsequently:
1
Press the
POWER
button on the remote control.
The message “Shop Mode, Menu language, Channels
and Time will be set.” is displayed.
Press the ENTER button, then “Select the Home Mode
when installing this TV at home” menu is automatically
displayed.
3
Press the or button to select language, then
the ENTER button.
“Select the antennas to memorize” menu is
automatically displayed.
4
Press the or button to memorize the channels of
the selected connection.
Press the ENTER button to select “Start”.
2
Press the or buttons to select “Shop” or “Home”,
then the ENTER button.
Then “Select the language of the OSD” the menu is
automatically displayed.
Operation
If the antenna is connected to ANT 1(AIR), select “Air” and if it is
connected to ANT 2 (CABLE), select “Cable”.
If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select “Air + Cable”.
In Cable mode, you can select the correct signal source among STD,
HRC, and IRC by pressing the or button, then press the
ENTER button.
Contact your local cable company to identify the type of cable system
that exists in your particular area.
continued...
We recommend setting the TV to Home mode for the best picture in your
home environment.
Shop mode is only intended for use in retail environments.
If the unit is accidentally set to Shop Mode, press and hold the MENU
button on the side panel of the TV for five seconds to return to Dynamic
(Home) mode.
To Next Page
Loading...
