Problem
Possible
Solution
, .
.'.
.
."
The
picture appears distorted
.in
the If Screen Fit
is
selected with some external devices, the picture may appear distorted
in
corner
of
the
!:]creen.·
the corner of the screen. This symptom
is
caused by the external devices, not
TV.
The 'Resets all settings to the This appears when you press
and
hold the
EXIT
button for a while The product settings
default values:' message appears. are reset
to
the factory defaults.
® This TFT LCD panel uses a panel consisting of sub pixels
(6
220 800) which require sophisticated technology
to
produce.
However, there may
be
few bright or dark pixels
on
the screen. These pixels will have
no
impact
on
the performance of the
product.
• Installing
the
Stand
1. Attach your LCD TV
to
the stand.
®
Two
or more people should carry the
TV.
® Make sure to distinguish between the front and back of the stand when attaching
it.
®
To
make sure the TV
is
installed
on
the stand at a proper level, do not apply excess downward pressure
to
the upper left
of right sides
of
the
TV.
2.
Fasten two screws at position 0 and then fasten two screws at position
8.
® Stand the product
up
and fasten the screws. If you fasten the screws with the LCD TV placed down,
it
may lean
to
one
side.
•
Disconnecting
the
Stand
, t
~
1.
Remove four screws from the back
of
the
TV.
2.
Separate the stand from the
TV.
®
Two
or more people should carry the
TV.
3.
Cover the bottom hole with the cover.
To Next Page
Loading...
