4-36
4. Troubleshooting
4-6-2 RS-232C
2-1.
- Before S/W Update, set the value “Service Select Debug/DL”
- To set the value, enter to “1.Option Table (Service) -> Control”
2-2.
- Set the value “Debug On”
- To enter “4. Advanced Menu”, we have to press the Password.
( now, Password is “0000”)
- Turn off (=AC Power off) the Set (waiting a few seconds) and turn on again.
Caution !!! If Debug is on, Wall_Mount is not active.
Debug On : RS-232C (Baudrate=115200 bps) for Debugging
Debug Off : RS-232C (Baudrate=9600 bps) for Wallmount
To Next Page
Loading...
