4-37
4. Troubleshooting
2-3. Install the MTK Tool
- Connect Set (Service JACK) and JIG Cable to execute Program Update.
JIG Cable (RS-232C cable)
2-4. Turn on the Set (or on Stand by mode)
- Run “MTK Tool”
Click Reset
Choose MT8226
Select Com Port
(Auto Detect)
Select Bin le
(to update new S/W version le),
by Browse
Click Upgrade button
2-5. If Upgrade is nished, Turn off (=AC Power off) the Set (waiting a few seconds) and turn on again.
To Next Page
Loading...
