Problem Possible Solution
I want to start Anynet+.
•
Check if the Anynet+ device is properly connected to the TV
and check if the❑Anynet+❑(HDMI-CEC) is set to On in the
System menu.
•
Press the TOOLS button to display the Anynet+ menu and
select a menu you want.
I want to exit Anynet+.
•
Select View❑TV in the Anynet+ menu.
•
Press the SOURCE button on the TV remote control and select
a device other than Anynet+ devices.
•
Press
❑CH❑
to change the TV mode. (Note that the
channel button operates only when a tuner-embedded Anynet+
device is not connected.)
To Next Page
Loading...
