English-14
Changing Channels
1. Press the CH or CH button to change channels.
When you press the CH or CH button, the TV changes channels in sequence.
You will see all the channels that the TV has memorized. (The TV must have memorized
at least three channels). You will not see channels that were either erased or not
memorized. See page 16 to memorize channels.
If you want to reset this feature...
1. Press the MENU button to display the menu.
Press the or button to select “Setup”, then press the ENTER button.
2. Press the ENTER button again, to select “Plug & Play”.
3. The message “Start Plug & Play” is displayed.
If you wish more details on the options of the setup, refer to the previous page.
Plug & Play can only be accessed in the TV mode.
Using the Channel Buttons
1. Press the PRE-CH button.
The TV will switch to the last channel viewed.
To quickly switch between two channels that are far apart, tune to one channel, then use
the number button to select the second channel. Then use the
PRE-CH button to quickly
alternate between them.
Using the PRE-CH Button to select the Previous Channel
Adjusting the Volume
1. Press the
VOL or VOL
buttons to increase or decrease the volume.
1. Press MUTE button and the sound cuts off.
The word “ ” will appear in the lower-left corner of the screen.
2. To turn mute off, press the MUTE button again, or simply press the
VOL or VOL
buttons.
Using Mute
At any time, you can cut off the sound using the MUTE button.
BN68-01001W-00Eng.qxd 7/24/06 8:04 PM Page 14
To Next Page
Loading...
