Samsung MCM-D211UN - Page 17

17
ENGLISH
Selecting a solderless terminal
1. Select a solderless terminal on the basis of nominal sectional area for a connecting power cable.
2. Insulate the solderless terminal and connection part of the connecting power cable with sheath.
Silver solder
Norminal dimensions for cable [mm



   











B











 




D
   









   







E    
F    
L    

   









t    
Welding with nitrogen blowing
① ③ ④ ⑤
⑥
⑥
②
Refrigerant pipe
Location for welding
Tape
Hands valve
Reducing valve
Nitrogen gas
1. When welding a pipe, perform nitrozen blowing work.
 

2. When inputting the nitrogen gas, the rate of ow for nitrogen gas should be less than 0.02MPa using
the reducing valve. (You should be able to feel the degree on your skin.)
DB68-06643A-03_IM_ACC UCK Kit_AA_EN.indd 17DB68-06643A-03_IM_ACC UCK Kit_AA_EN.indd 17 2023-01-13 오전 11:35:122023-01-13 오전 11:35:12