Samsung ME83D - Troubleshooting and Error Code; Common Oven Operational Issues; Error Code SE Explanation

English - 19
03 COOKWARE GUIDE & tROUblEshOOtInG
troubleshooting and error code
TROUBLESHOOTING
If you have any of the problems listed below try the solutions given.
This is normal.
• Condensationinsidetheoven.
• Airowaroundthedoorandoutercasing.
• Lightreectionaroundthedoorandoutercasing.
• Steamescapingfromaroundthedoororvents.
The oven does not start when you press the (
) button.
• Is the door completely closed?
The food is not cooked at all.
• Have you set the timer correctly and/or pressed the (
) button?
• Isthedoorclosed?
• Haveyouoverloadedtheelectriccircuitandcausedafusetoblowora
breaker to be triggered?
The food is either overcooked or undercooked.
• Was the appropriate cooking length set for the type of food?
• Wasanappropriatepowerlevelchosen?
Sparking and cracking occur inside the oven (arcing).
• Have you used a dish with metal trimmings?
• Haveyouleftaforkorothermetalutensilinsidetheoven?
• Isaluminumfoiltooclosetotheinsidewalls?
The light bulb is not working.
• The Light bulb should not be replaced in person for safety reasons.
Please contact nearest authorised Samsung customer care, to arrange
for a qualified engineer to replace the bulb.
The oven causes interference with radios or televisions.
• Slight interference may be observed on televisions or radios when the
oven is operating. This is normal. To solve this problem, install the oven
away from televisions, radios and aerials.
• If interference is detected by the oven’s microprocessor, the display
may be reset. To solve this problem, disconnect the power plug and
reconnectit.Resetthetime.
If the above guidelines do not enable you to solve the problem, then
contact your local SAMSUNG customer service centre.
Please have the following information read.
• The model and serial numbers, normally printed on the rear of the
oven
• Your warranty details
• A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.
ERROR CODE
“SE” message indicates.
•The“SE”messageisCleanthekeysandcheckifthereiswateron
the surface around key. Turn off the microwave oven and try setting
again.Ifitoccursagain,callyourlocalSAMSUNGCustomerCare
Centre.
ME83D-1W_XSA_DE68-04225C_EN.indd 19 04/10/2013 18:57:37