APPENDIX
Installing Optional Memory Card
7
Push the SIMM down until it snaps into
place.
Make sure that the SIMM is secured in
place by the metal clips and pins on
both sides of the connectors.
9
Reconnect the printer cable and the
power cord and turn the printer on.
Then, replace the supports.
8
Reassemble the shield cover, turn the
printer back over, and replace the toner
cartridge.
Pin
Metal clip
Note: When you disassemble the
memory card, push out on the metal
clips at each end of the connector, and
pull it as shown.
A.33
To Next Page
Loading...
