PRINT MEDIA
4.10
Printing on Labels
Guidelines
• Only use labels recommended for laser printers.
• Verify that the labels’ adhesive material can tolerate fusing temperature of 200°C
(392°F) for 0.1 second.
• Make sure that there is no exposed adhesive material between the labels. Exposed areas
can cause labels to peel off during printing, which can cause paper jams. Exposed
adhesive can also cause damage to printer components.
• Do not feed a sheet of labels through the printer more than once. The adhesive backing
is designed for one pass through the printer.
• Do not use labels that are separating from the backing sheet or that are wrinkled,
bubbled, or otherwise damaged.
22
Push the output lever down.
11
Load labels in the input tray you want
to use with print side up.
Adjust the guide to fit the width of the
labels.
33
When you print on labels, configure the
paper source, type and size in the
software application. For details, see
page 5.3.
Note: To prevent them from sticking
together, do not let the printed label
sheets stack up as they are printed out.
To Next Page
Loading...
