REQUIRED SUPPLIES
1. New replacement toner for use in Samsung ML-2165W / MLT-D101S
2. New replacement chip for use in ML-2165W to match region
3. New OPC drum (optional)
4. New developer roller (optional)
5. New PCR (optional)
6. New doctor blade (optional)
7. Self-tapping cartridge screws 1/8” x 1/4” (7 pieces)
8. Conductive grease
9. 99% isopropyl alcohol
10. Wiper blade lubricating powder
1. Place the cartridge in position, and with the chisel blade section, the head of each plastic rivet holding the left end cover.
SAMSUNG ML-2165W (MLT-D101S) TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2013 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact techsupport@uninetimaging.com
www.uninetimaging.com
2. Mark the center of each cut and drill a hole with the small
drill bit no deeper that 3/16”.
To Next Page
Loading...
