Service Manual
Alignment & Troubleshooting
4-26
Samsung Electronics
5) Light Image
Description: The printed image is light, with no ghost.
2. Ambient temperature
is below than 10°C.
3. Bad contact
caused by the toner stains
between the high voltage terminal in
the HVPS and the one
in the set.
4. Abnormal output
from the HVPS.
(Run self-test and check 1~4)
1. Develop roller is
stained when the toner of toner
cartridge is almost consumed.
Check if the Toner Save mode is off.
Check if the density is light.
No 1 : Replace the toner cartridge
and try to print out.
No 2 : Wait 30 minutes after printer
is powered on before you
start printing.
No3 : Clean up the contaminated
area by the toner.
Replace the HVPS if the
problems are not solved by the
above four instructions.
To Next Page
Loading...
