ENG
49
50
MISCELLANEOUS
Connecting Headphones/Microphone
•
The loudspeakers are no longer used to
output the sound.
Connect the headphones
to the PHONES jack on
the front panel.
•
Prolonged use of headphones at a high volume may damage your hearing.
Note
Plug a microphone with a 3.5ø MIC
jack into the Mic terminal.
•
Connect one Microphone.
•
Press the MIC VOL button to adjust the MIC level.
•
Press the ECHO button to select ECHO1,ECHO2, and ECHO OFF.
You can connect a set of headphones to your micro component system so that you can listen
to music or radio programmers without disturbing other people in the room. The headphones
must have a 3.5ø jack or an appropriate adapter.
You can also insert microphone to sing along with your favorite Cds.
•
The various functions available are listed in turn on the display.
•
All these functions are described in detail in this booklet.
For instructions on how to use them, refer to the appropriate sections.
DEMO Function
You can view the various functions available on your system.
DEMO Function / DIMMER Function
•
Each time the button is press, the brightness changes as follows:
DIMMER ON(Dim) DIMMER OFF(Bright).
DIMMER Function
You can adjust the brightness of the display on the main unit so it won't
interfere with your movie viewing.
Press DEMO/DIMMER button.
Press DEMO/DIMMER button.
Press any buttons to cancel DEMO function.
When you turn off the main unit, DEMO function will be auto start
after 10 senconds. if you want to cancel this DEMO function, press
DEMO/DIMMER button again.
Note
MM-C330D-Latin-xsp-ENG-2.indd 48-49MM-C330D-Latin-xsp-ENG-2.indd 48-49 2010-3-4 8:43:072010-3-4 8:43:07
To Next Page
Loading...
