Listening to a Cassette
Always treat your cassettes with care; refer, if necessary, to the section entitled
“Precautions When Using Audio Cassettes” on page 40.
•
Insert a cassette with the
recording/playback side facing
the cassette holder, and then
push the cassette door shut.
21 3
Press TAPE on
the player to
select the Tape
function.
Switch the system
on by pressing
POWER.
•
Rewind the cassette / DOWN
button.
•
Fast-forward the cassette UP /
button.
54
•
Side A : Tape ( ) button once.
•
Side B : Tape ( ) button twice.
Press the PUSH
EJECT( ) of the
cassette deck to open
the cassette door and
insert a cassette.
Press the ,
button or ,
button on the remote
control
if necessary.
6
When you have
finished playback,
press STOP button.
Press the button
or on the remote
control. The cassette
starts playing.
Selecting the cassette Playback
Mode/Repeat A↔ B /Tape Counter
Function
•
Use this to listen to a specific section again during playback.
•
Set the start and end points of the section you want to repeat 3 times.
•
This is a useful when learning a foreign language.
•
The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Press REP. A↔B button.
•
You cannot set the end point (B) within 7 seconds after setting the start point (A).
•
Repeat A-B Function is available for TAPE only.
Note
REPEAT
A↔B Function
Press REVERSE MODE until the appropriate
symbol is displayed.
•
: One side of the selected cassette and then stops.
•
:
One side of the cassette.
The other side of the cassette and then stops.
•
: Both sides of the cassette indefinitely until you
press stop.
Your micro component system has three cassette playback modes which
enable you to listen to both sides of a cassette automatically. .
Selecting the Cassette Playback Mode
•
Before starting to record a cassette for which you wish to take
note of the counter values at the beginning of each track, reset
the counter by pressing and hold COUNTER RESET .
When playing a cassette , a counter is displayed to enable you to
take note of the counter value at the start of each track to start
playback at the beginning of the track to which you wish to listen.
Tape Counter
30
29
TAPE DECK
To Next Page
Loading...
