Samsung MRK-A10N - Page 134

Control Systems
134
IVIV
Power distribution system
1. Electricity meter interface module
9) MIM-B16N menu structure
󱀣 MIM-B16N
Main menu Sub menu Description
Monitoring
1*."EESFTT
5IF.*.#/BEESFTTJTEJTQMBZFEXJUIUIFQIZTJDBMBEESFTT48BEEFECZ)POUIF
LCD window.
Ex)
Option SW
Option switch setting to ON is displayed with the position number at the corresponding
positions while setting to OFF is shown with the mark ‘X’.
Ex)
1.2 Option S/W
1X
Example display : 1X
tOption switch 1 : On
tOption switch 2 : Off
Micom version
*UEJTQMBZT1*.TPGUXBSFWFSTJPO
Ex)
1.3 Micom Ver.
130123
DB Code
*UEJTQMBZT1*.TPGUXBSF%#DPEF
Ex)
1.4 DB Code
DB91-01128A
Configuration
1BTTXPSE
The password, which is asked to enter to change the configuration setting, is used to prevent
VOBVUIPSJ[FEQFSTPOTGSPNBDDFTTJOH.*.#/'BDUPSZTFUUJOHJTA
Ex)
Meter type
You can select each channel’s meter type.
%FGBVMUWBMVF1PXFS.FUFS
5ZQF1PXFS.FUFS(BTNFUFS8BUFS.FUFS
1VMTF8JEUI
You can set pulse rate of meter which connected to each channel.
[Range]
1PXFSNFUFS_8IQVMTF/PEFDJNBMQVMTFSBUFBMMPXFE
(BTNFUFS_N
3
/pulse
8BUFSNFUFS_MJUFSQVMTF/PEFDJNBMQVMTFSBUFBMMPXFE
Date & time You can set current date and time.
Channel use
You can set Enable/Disable state of each channel.
*GZPVTFUi%JTBCMFwUIFO1*.EPFTOUEJTQMBZNFUFSWBMVFPGUIFEJTBCMFEDIBOOFM
Value set Initial meter value must be set as a starting point for each of the enabled interface channels.
Value clear Each or all the initial meter values are cleared when selected.
LCD SW2 setting
) 
31H 1
… …
37H 7
1*. FixedAddress
1.Monitoring
1.1 Address
1.1 Address
58 30 FF
[¥]UwGG¥UGGGXZ[ YWX[TW[TY\GGG㝘䟸G[aZ]aZX