Samsung MX-HS6000 - Selecting a Stored Station; Timer Function; Setting the Clock; Setting the Timer

03 Functions
3.
Select a station by:
•
Pressing and holding the TUNING/
ALBUM
,
or
.
button on the remote
control to automatically search for active
broadcasting stations.
4.
Press the MO/ST button to switch between
stereo and mono.
•
In a poor reception area, select MONO
for a clear, interference-free broadcast.
•
This applies only when listening to an
FM station.
5.
If you do not want to store the radio station
found, go back to Step 3 and search for
another station.
Otherwise:
a.
Press the
¬
button.
b.
Or, press the TUNING/ALBUM button
on the remote control to select a
program number in the PRESET mode.
c.
Press the
¬
button to save the preset.
6.
To store any other radio frequencies
required, repeat Steps 3 to 5.
| NOTES |
✎
In Tuner mode
- In the Manual mode, you can use the
1

or

2
button or the DJ JOG control.
- In the Preset mode, you can use the
1

or

2
button or the DJ JOG control on
the product to search for a stored radio
station.
Selecting a Stored Station
To listen to a stored station, follow these steps:
1.
Select FM by pressing the TUNER/AUX
button on the product or remote control.
2.
Press the TUNING MODE button on the
remote control until “PRESET” is displayed.
3.
Press
1
,
2
button on the main unit or
TUNING/ALBUM
,
,
.
on the remote
control to select a preset number.
or
Turn the DJ JOG control left or right on
the main unit to select the stored station.
Timer Function
Setting the Clock
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
1.
Press the TIMER SET button on the remote
control twice. "CLOCK " is displayed.
2.
Press the
¬
button on the remote
control. The hour flashes.
•
T
o increase the hours: TUNING/ALBUM
,
•
To decrease the hours: TUNING/ALBUM
.
3.
When the correct hour is displayed, press
the
¬
button, and then the minutes
flash.
•
To increase the minutes: TUNING/
ALBUM
,
•
To decrease the minutes: TUNING/
ALBUM
.
4.
When the correct minute is displayed,
press the
¬
button, and then " TIME"
appears in the display.
Setting the Timer
The timer enables you to set the product to
switch on or off at specific times automatically.
•
Before setting the timer, check that the
current time is correct.
•
For each step, you have a few seconds to set
the required options. If you exceed this time,
you must start again.
•
If you no longer want the product to be
switched on or off automatically, you must
cancel the timer by pressing the TIMER
ON/OFF button.
Example: You want to wake up to
music every morning.
1.
Press the TIMER SET button until TIME
is displayed.
2.
Press the
¬
button.
Result: ON is displayed for a few seconds.
You can set the timer switch-on time.
21 English
02680D-MX-HS6000-ZA-ENG-20140304.indd 21 2014/3/17 15:47:46