1-22
Regulatory Compliance Statements
Wireless Guidance
Low power, Radio LAN type devices (radio frequency (RF) wireless communication devices),
The following section is a general overview of considerations while operating a wireless device.
country sections (or country group sections). The wireless devices in your system are only
label. If the country you will be using the wireless device in, is not listed, please contact your
local Radio Approval agency for requirements. Wireless devices are closely regulated and use
may not be allowed.
are well below all international RF exposure limits as known at this time. Because the wireless
devices (which may be embedded into your notebook) emit less energy than is allowed in radio
frequency safety standards and recommendations, manufacturer believes these devices are
during normal operation.
Some circumstances require restrictions on wireless devices. Examples of common
restrictions are listed on the next page:
Radio frequency wireless communication can interfere with equipment on commercial
aircraft. Current aviation regulations require wireless devices to be turned off while
traveling in an airplane.
devices are examples of devices that provide wireless communication.
In environments where the risk of interference to other devices or services is harmful
or perceived as harmful, the option to use a wireless device may be restricted or
limited examples where use of wireless devices may be restricted or eliminated. When
in environments where you are uncertain of the sanction to use wireless devices, ask
Every country has different restrictions on the use of wireless devices. Since your
system is equipped with a wireless device, when traveling between countries with your
system, check with the local Radio Approval authorities prior to any move or trip for
any restrictions on the use of a wireless device in the destination country.
If your system came equipped with an internal embedded wireless device, do not
operate the wireless device unless all covers and shields are in place and the system
is fully assembled.
for service.
Only use drivers approved for the country in which the device will be used. See the
manufacturer System Restoration Kit, or contact manufacturer Technical Support for
additional information.