Samsung NP-R620E - Changing the Boot Priority

Boot Device Priority
[Boot priority order]
N/A
1. IDE CD : xxxxxxxxxxxxxxxxxxx
2. IDE HDD : xxxxxxx xxxxxxx
3 .USB KEY : N/A
4. USB CDROM : N/A
5. USB FDC : N/A
6. USB HDD : N/A
7. PCI BEV : N/A
8.
- PCI SCSI : N/A
- USB ZIP : N/A
- USB LS120 : N/A
[Excluded from boot order]
Select system boot
options
Boot Device Priority
NumLock [Disabled]
Enable Keypad [By NumLock]
Summary screen [Disabled]
Boor-time Diagnostic Screen [Disabled]
PXE OPROM [Only with F12]
Brightness Mode Control [Auto]
Wireless Device Control [Always On]
Smart Battery Calibration
148
1
 SelecttheBootmenuintheBIOSSetup.
2
 Press<Enter> on the Boot Device Priorityitem.
3
 Pressthedownkey(↓)tomovetotheIDE HDD
itemand press the F6keytomoveuptothetopitem.
4
 PresstheF10keytosavethesettingsandexit
Setup.Thehighestbootprioritydeviceisnowsetto
theHardDrive.
Changing the Boot Priority
ThedefaultbootpriorityofyourcomputeristheCD-ROMrst,thenaremovabledeviceandthentheharddiskdrive
inthisorder.
Bydefault,thehighestbootprioritydeviceissettotheCD-ROM/DVDdrive.Asanexample,theproceduresto
changethehighestbootprioritydevicetotheharddiskdrivearedescribedbelow.