My Camera
34
Charging the battery and turning on your camera
Charging the battery
Before you use the camera for the rst time, you must charge the battery.
Plug the small end of the USB cable into your camera, and then plug the
other end of the USB cable into the AC adapter.
Status lamp
• Red light on: Charging
• Red light o: Fully charged
• Red light blinking: Error
•
Use only the AC adapter and USB cable supplied with your camera. If you use
another AC adapter, the camera battery may not charge or work properly.
•
You can charge the battery with the USB cable only when the camera is turned
o.
Turning on your camera
Set the Power switch to ON.
•
To turn your camera o, set the Power switch to OFF.
•
The initial setup screen appears when you turn on the camera for the
rst time. (p. 35)
To turn your camera o, set the Power switch to
www.devicemanuals.eu
To turn your camera o, set the Power switch to
The initial setup screen appears when you turn on the camera for the
www.devicemanuals.eu
The initial setup screen appears when you turn on the camera for the
To Next Page
Loading...
