Samsung PL-42P7HP - 3-2 How to Access Service Mode

Alignment & Adjustment
3-2 Samsung Electronics
3-2 How to Access Service Mode
1. General Remote
To Enter : Power Off → MUTE → 1 → 8 → 2 → Power On
(Interval between key strokes : less than 3 sec)
To Exit : Power Off → On
2. Factory Remote
To Enter : Power On → INFO → FACTORY Key (Interval between key strokes : less than 3 sec)
To Exit : Power Off → On
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off)
4. Adjustment Procedures
- Channel ▲▼Key : Select an item.
- Volume ◀▶ Key : Adjust the value up or down.
- MENU Key : Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
1. Calibration XXXXX XXXXX 7. YC Delay
2. Option Table XXXXX XXXXX 8. Adjust
3. White Balance 9. -----
4. SVP-FX 10. W/B Movie
5. Option Block 11. Checksum
6. STV8258/STA323W 12. Reset
T-SPRN42NUS-XXXX
T-SPRMNUS-S-XXXX Boot Merge:OK
Month / Day / Year
Hour / Min. / Sec.