Picture Options
❑
You can customize the additional picture settings to suit your preference.
In
N PC mode, you can only make changes to the Colour Tone, Size and Screen
Burn Protection from among the items in Picture Options.
Colour Tone → Cool / Normal / Warm1 / Warm2
You can select the most comfortable colour tone to your eyes.
The adjusted values are stored according to the selected Picture mode.
N
Warm1 N or Warm2 is only activated when the picture mode is Movie.
Size
You can select the picture size which best corresponds to your viewing requirements.
16:9 • : Sets the picture to the 16:9 aspect ratio.
Wide Zoom • : Magnify the size of the picture more than 4:3.
Zoom • : Magnies the 16:9 wide picture (in the vertical direction) to t the screen size.
4:3 • : Sets the picture to the 4:3 aspect ration.
Screen Fit : • Use the function to see the full image without any cutoff when HDMI (720p/1080i/1080p) or Component
(1080i/1080p) signals are input.
The picture size options may vary depending on the input source.
N
The items available may differ depending on the selected mode.
N
In
N
PC Mode, only 16:9 and 4:3 mode can be adjusted.
Settings can be adjusted and stored for each external device you have connected to an input of the TV.
N
Temporary image retention may occur when viewing a static image on the set for more than two hours.
N
Wide Zoom
N
: Press the ► button to select Position, then press the ENTER
E
button.
Press the ▲ or ▼ button to move the screen up / down. Then press the ENTER
E
button.
Zoom
N
: Press the ► button to select Position, then press the ENTER
E
button. Press the ▲ or ▼ button to move the
picture up and down. Then press the ENTER
E
button. Press the ► button to select Size, then press the ENTER
E
button.
Press the ▲ or ▼ button to magnify or reduce the picture size in the vertical direction. Then press the ENTER
E
button.
After selecting
N
Screen Fit in HDMI (1080i / 1080p) or Component (1080i / 1080p) mode: Select Position by pressing
the ◄ or ►button. Use the ▲, ▼, ◄ or ► button to move the picture.
Reset
N
: Press the ◄ or ► button to select Reset, then press the ENTER
E
button. You can initialize the setting.
If you use the
N
Screen Fit function with HDMI 720p input, 1 line will be cut at the top, bottom, left and right as in the overscan
function.
You can select these options simply by pressing the
O
P.SIZE button on the remote
control.
Digital NR → Off / Low / Medium / High / Auto
If the broadcast signal received by your TV is weak, you can activate the Digital Noise
Reduction feature to help reduce any static and ghosting that may appear on the screen.
When the signal is weak, select one of the other options until the best picture is displayed.
N
HDMI Black Level → Normal / Low
You can directly select the black level on the screen to adjust the screen depth.
This function is active only when the external input connects to HDMI (RGB signals).
N
Continued...
Tint (G/R) : G50/R50
Advanced Setting
Picture Options
►
Picture Reset
Picture
To Next Page
Loading...
