68
Chapter 5. Menu
System ▼
2nd 3rd Description
Standby Control You can set the screen standby mode to be applied when an input signal is received.
• Available only DVI, HDMI, DisplayPort mode.
• Ensure that the source device is connected correctly when the Signal is weak or no signal message appears.
• If No Signal Message is set to Off, the Signal is weak or no signal message does not appear. Set No Signal
Message to On.
Network Standby This feature keeps the network power on when the product turns off.
Power Button The power button (on the top left corner of the remote control) can be set to either turn on the power or turn on/off
the power.
Eco Solution Energy Saving Mode Reduce the power consumption by adjusting the screen brightness.
Eco Sensor To enhance your power savings, the picture settings will automatically adapt to the light in the room.
• Adjusting the Backlight setting in the Picture menu disables the Eco Sensor.
• If Eco Sensor is On, the display brightness may change (become slightly darker or brighter) depending on the
surrounding light intensity.
Screen Lamp Schedule Adjust the panel brightness. A value closer to 100 makes the panel brighter.
No Signal Power Off Save power by turning the device off when no signal is received from any source.
• Disabled when an attached PC is in power saving mode.
• The product will automatically power off at a specied time. The time can be changed as required.
Auto Power Off The product will automatically turn off if you don’t press a button on the remote or touch a button on product front
panel within select hours to prevent overheating.
To Next Page
Loading...
