Disassembly & Reassembly
Samsung Electronics 12-1
12. Disassembly & Reassembly
12-1 Overhaul Disassembly & Reassembly
Notice
- Be sure to separate the power cord before disassembling the unit.
- Discharge the capacitors first when separating PCB's with high capacity capacitors such as SMPS, X Main Board, Y Main
Board, etc. (A spark may be generated by the electric charge, and there is danger of electronic shock.)
- Check that the cables are properly connected referring to the circuit diagram when disassembling or assembling the unit
taking care not to damage the cables.
- Take care not to cause a flaw in the Glass Filter in the front.
- Assemble the boards in the reverse order of the disassembly.
- The plasma must be layed down on a flat padded surface for disassembly and reassembly.
Part Name Description Description Photo
Cover
Rear
① Remove 4 screws.( )
: M8,L16,ZPC(BLK),SWRCH18A,WP
② Remove 14 screws.( )
: BH,+,B,M4,L12,ZPC(BLK)
③ Remove 4 screws.( )
: BH,+,S,M4,L10,ZPC(BLK)
④ Remove the ASSY COVER REAR.
12-1-1 Separation of ASSY STAND P-BASE
Part Name Description Description Photo
Stand
① Remove 4 screws.
: PH,+,WSP,S,M4,L35,ZPC(BLK)
② Pull the ASSY STAND P-BASE down to remove it from
the unit.
: Please lay the PDP unit face down on a soft surface
when removing the stand.
12-1-2 Separation of ASSY COVER P-REAR
To Next Page
Loading...
