Samsung PS42C7HX/XEC - 11-1-3 Remote Control

Operation Instruction & Installation
Samsung Electronics 11-3
11-1-3 Remote Control
The performance of the remote control may be affected by bright light.
This is a special remote control for the visually impaired, and has Braille points on the Power, Channel and
Volume buttons.
1
POWER button
(turns the TV on and off)
2
Number buttons for direct
channel access
3
One/Two-digit channel
selection
4
Channel control button
5
Selects the TV mode directly
6
Volume increase
Volume decrease
7
Temporary sound switch-off
8
Displays the main on-screen
menu
9
Picture-In-Picture On/Off
10
Sound effect selection
11
Picture effect selection
12
Adjust screen brightness to
surrounding environment
14
Sound mode selection
15
TruSurround XT mode button
16
Remote control setup
17
Selects a target device to be
controlled by the Samsung
remote control (TV, DVD,
STB, CABLE, VCR)
18
Available source selection
19
Previous channel
20
Automatic Power-off
21
Selects the PC mode directly
22
VCR/DVD Function
(Rewind, Stop, Play/Pause,
Fast/Forward
23
Next channel
Previous channel
24
Exit the on-screen menu
25
Control the cursor in the menu
26
Use to see information on the
current broadcast
28
Picture freeze
29
Picture size selection
30
Select the channel of sub
picture (PIP)
32
If your remote control is not
functioning properly, take out
the batteries and press the
reset button for about 2~3
seconds.
Re-insert the batteries and
try using the remote control
again.
Teletext Functions
5
Exit from the teletext display
(depending on the model)
8
Teletext index
9
Teletext hold
13
Teletext store
18
Teletext mode selection
(LIST/FLOF)
19
Teletext sub page
23
P : Teletext next page
P : Teletext previous page
24
Teletext cancel
26
Teletext reveal
27
Teletext display/mix both
teletext information and
the normal broadcast
31
Teletext size selection
10 11 28 29
Fastext topic selection