Reference Information
Samsung Electronics 14-1
14. Reference Information
14-1 Connection to a 3rd Party Device
Notice: 1. Do not connect to the power source until all connections are done, as this will cause damage to the product.
2. Make sure the sound port is properly connected (right: red, left: white).
14-1-1 Connecting to an Aerial or Cable Television Network
14-1-2 Connecting a Satellite Receiver or Decoder
To view television channels correctly, a signal must be received by
the set from one of the following sources:
An outdoor aerial
A cable television network
A satellite network
1 In the first three cases, connect the aerial or network input cable to
the ANT IN jack on the rear of the television.
2 If you are using an indoor aerial, you may need to turn it when
tuning your television until you obtain a picture that is both sharp
and clear.
For further details, refer to:
“Storing Channels Automatically” on page 17
“Storing Channels Manually” on page 18
When installing or re-installing your TV, be sure to use the
supplied coaxial antenna cable. If you connect using a different
coaxial cable, there is risk of noise or interference to the screen
image. (You must not use another general purpose cable.
Use the 3M/5M/7M cable supplied by Samsung.)
Rear of the TV
Cable Television
Network
or
In order to watch television programmes broadcast via a satellite network,
you must connect a satellite receiver to the rear of TV. Also, in order to
descramble a coded transmission signal, you must connect a decoder to
the rear of TV.
Using a SCART cable
Connect the receiver (or decoder) SCART cable to one of the
SCART connectors on the rear of the television.
Using a coaxial cable
Connect a coaxial cable to the:
Receiver (or Decoder) output socket.
Television aerial input socket.
If you wish to connect both a satellite receiver (or decoder) and
a VCR, you should connect the:
Receiver (or Decoder) to the VCR
VCR to the television
Otherwise, connect the receiver (or decoder) directly to the
television.
Rear of the TV
Satellite receiver/
Decoder
To Next Page
Loading...
