Troubleshooting
Samsung Electronics 4-17
4-2-2 How to Access Service Mode
1. General Remote
To Enter: →→→→
(Interval between key strokes: less than 3 sec)
To Exit: →
2. Factory Remote
To Enter: →→→(Interval between key strokes: less than 3 sec)
To Exit: →
Press the Factory key twice with a key stroke interval of more than 1 second (Pressing once enters Aging Mode)
3. Settings when entering Factory mode
- Sharp Screen (Dynamic), Color Tone (Cool1), Factory (Dynamic CE Off)
4. Adjustment Procedures
- Channel ▲▼Key : Select an item.
- Volume ◀▶ Key : Adjust the value up or down.
- MENU Key : Save the changes to the EEPROM and return to the higher-level mode.
- Using the Numeric (0~9) keys, you can select a channel.
- Using the SOURCE key, you can switch AV modes.
5. Initial SERVICE MODE DISPLAY State
※ The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the
improvement of product functions.
※ If you have adjusted the settings in Service Mode, you have to reset the product.
POWER OFF INFO POWER ON
POWER OFF POWER ON
POWER OFF POWER ON
MENU MUTE
POWER ON INFO FACTORY Key
Panel ON time(Hour) 00002 L24E_RS TV P 1
1. Calibration 7. YC Delay
2. Option Table (Service) 8. Adjust
3. White Balance 9. Bus Stop
4. MST68981 10. W/B MOVIE
5. Option Block 11. Checksum
6. Sound 12. Reset
T-LIL2PEUMD-XXXX 13. Spread Spectrum
Month/ Day/ Year
Hour/ Min/ Sec
To Next Page
Loading...
