To connect the One Invisible Connection to the One Connect and your TV, follow these steps:
1. After the TV is completely set up and placed in its final position, connect the One Invisible Connection to the One Connect and
the TV as shown in Steps 1 to 4 above.
WARNING: Make sure that both connectors are fully and firmly connected. If either connecter is not connected properly, there
is a danger of severe electric shock.
2. Connect the One Connect AC power cord to the One Connect, and then connect the cord to a wall outlet as shown in Step 5
above.
WARNING: Follow the directions exactly. Be sure to connect the power cord to the wall outlet as the last step. Always
disconnect the power cord from the wall outlet before disconnecting the One Invisible Connection from the back of the TV or
from the One Connect.
See the illustrated Quick Setup Guide for more information.
3. Connect your peripherals (aerial, cable box, Blu-ray player, etc.) to the One Connect. See the Accessory Kit for details.
Do not use the One Connect in the upside-down or upright position.
When connecting the One Invisible Connection, use a Bending Cover, which prevents the cable of the One Invisible
Connection from being bent at a 90 degree angle, to bend the cable. Failure to do so may cause damage to the cable.
When connecting the One Invisible Connection, pay attention to the shapes and sizes of its connectors so that they are
connected correctly. Failure to do so may cause product malfunction
When connecting the One Invisible Connection, be careful not to twist the cable of the One Invisible Connection. Failure to do
so may cause performance degradation of the TV or damage to the cable
When arranging the remaining cable, refer to the figure on the previous page for the correct arrangement.
Take care not to subject the cable to any of the actions below. The One Invisible Connection contains a power circuit. You
could damage the cable and subject yourself to an electric shock
Handle the One Connect carefully. It is heavy.
Bending
Twisting
Pulling
Pressing on