USING THE WATER DISPENSER
(OPTIONAL)
With the water dispenser, you can obtain chilled
water easily without opening the refrigerator door.
Lift up the Can Carry ( • 1 ).
Lift up and pull out the •
water tank ( 2 ).
Hold the handgrips on -
both sides to lift out the
water tank.
Clean the inside of water tank before using it for -
the first time.
Fill the water tank with water, ensuring that it is •
in a stable position, allowing for the extended
water supply outlet.
Fill with water up to 4.5 L. If it is filled higher -
than this, it may overflow when the lid is closed.
It is impossible to fill the tank with water while it -
is positioned in the refrigerator.
Method 1.•
Fill the water lifting the round lid in the arrow -
direction to open.
Method 2.•
Please fill the water after holding and lifting the -
large lid to open it.
When assembling the water tank after
cleaning, make sure the Dispenser cock
assemble. It may cause water leak.
CAUTION
Close the refrigerator door •
after fitting the water tank.
Confirm that the dispenser -
cock is outside after closing
the door.
Fix water tank to the
fridge door tightly.
If not, water tank may
not be operate correctly.
Do not use the refrigerator without
the water tank. If not, it may cause an
efficiency problem.
Do not fill anything other than water as
mineral water or purified water in the
water tank.
Place a glass underneath the water outlet and •
push gently against the dispenser lever with
your glass.
Make sure the glass is in line with the dispenser
to prevent the water from bouncing out.
Check that the locking device is set to
“UNLOCK”.
Water can only be dispensed on this
setting.
REMOVING THE INTERIOR PARTS
When assembling, put fridge shelves in
the correct position and do not put them
upside down. It may cause a personal
injury or material damage.
When you put the shelves back, make
sure the side with the label “Front” on it
face the front of the refrigerator.
CAUTION
CAUTION
CAUTION
CAUTION
1
2
Water tank
Dispenser cock
Round lid
Dispenser Lever
LOCK UNLOCK