Samsung RC140DHXGA - Setting Option Setup Method; Type a(Setting Option)

Samsung Electronics 4-4
4-3 Setting Option Setup Method
4-3-1 Type A(Setting Option)
Option No. :
Step 1 : Enter the Option Setup mode.
1
st
Take out the batteries of remote control.
2
nd
Press the temperature button simultaneously
and insert the battery again.
3
rd
Make sure the remocon display shown as .
Step 2 : Enter the Option Setup mode and select your option according to the following procedure.
1
2
3
4
5
6
The default value is .
Otherwise, push the
button to .
Every time you push the button, the display panel reads
or repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
   . . .
       repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
   . . .
       repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
   . . .
       repeatedly.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
   . . .
       repeatedly.
Setting is not required if you must
a volue which has a default.
Push the
button to set the display panel to .
Every time you push the button, the display panel reads
   . . .
       repeatedly.
1
2
3
4
5
6
NS090SDXEA_E_SM_33623A(1)_1.indd 4 2011-04-08 �� 10:55:05