Before calling service
ENGLISH
DA68-02659A REV(0.0)
If you have further questions or damaged accessory parts, contact us at 1-800-SAMSUNG (726-7864)
1. Automatic Ice Maker does not work
Allow your refrigerator to operate and cool down •
for 24 hours (1 full day) before the ice maker starts
producing ice.
12
3
6
9
Temperature Indicator moving)
•
refrigerator not to generate cool air. (Only for product sold in U.S)
•
but it does not make cool air. To cancel this mode, press the
“Cooling O
Key” at the same time for 5 seconds until “Ding-dong”
sounds.
COOLING OFF KEY
-
RL220 Model : Power Freeze + Freezer Key -
3. Water dispenser Intallation(On some models)
Turn on water installation and Flush 3 gallons through fi lter before use •
(fl ush approximately 6 minutes)
• The water fi lter must be installed outside the refrigerator.
It is not provided with your new refrigerator. The fi lter
cartridge (8) and holder (9) kit can be purchased from local
hardware store..
Do not use copper line.•
Cut the tubing, making sure the ends are square and clean. •
There are several items that you need to purchase to complete this
connection.
You may fi nd these items sold as a kit at your local hardware store.
Use Copper Tubing Use Plastic Tubing
¼” copper tubing
¼” compression nut (1pc)
Ferrule (2pc)
¼” plastic tubing
Molded end
(Bulb)
¼” compression nut (1pc)
4. Fridge or freezer Compartments are warm
Allow your refrigerator to operate and cool down for 24 hours (1 •
full day) to reach to the set temperature.
Also, into your refrigerator, it may need an additional•
24 hours for the fridge to reach the set temperature.
5. Moisture forms on outside/inside of refrigerator
•
hot and humid seasons.)
•
Saving function.
If you open the doors frequently or for too long, it may cause •
moisture inside the fridge.
6. Noise Clicks, Pops, Cracks, Snaps
These noises may be heard occasionally inside the refrigerator. •
This is normal. This sound occurs when various items contract
or expand while temperatures are changing; especially during
defrosting. This may also occur when electronic devices including
the ice maker are operating.
7. Display
Incorrect Correct
( 1 )
Freezer
(Hold 3 sec for
Power Freeze)
Press the Freezer button to set the freezer temperature
between colder and coldest.
Press and hold the Freezer button for 3 seconds to activate
Power Freezer function which speeds up the freezing
process in the freezer.
( 2 )
Fridge
Press the Fridge button to set the Fridge temperature
between colder and coldest.
( 3 )
Energy Saver
For better energy effi ciency, press the Energy Saver button.
If condensation occurs on the doors, turn the Energy Saver
( 4 )
button. The LED will light up and the Ice-Maker stops
making ice.
( 5 )
( 6 )
Power Freeze
Press this button to activate Power Freezer function which
speeds up the freezing process in the freezer.
8. Food stored in refrigerator is frozen
If food with too much moisture is stored near the cooling vents, it •
may get frozen. Be sure to keep moist food away from the cooling
vents.
9. Moving and Installing
When installing, servicing or cleaning behind the refrigerator, be •
sure of the following:
To protect your fl oor’s fi nish when •
moving the refrigerator, cut a large
section of the cardboard carton
and place under the refrigerator
where you are working.
Pull the unit straight out and push •
back in straight after fi nishing.
10. Leveling & Door Alignment
Insert a fl at-blade screwdriver •
into a slot on the control lever,
turn it clockwise or counter-
clockwise to level the door.
[RF221, RF220]
[RL225]
[RL220]
①
①
①
①
①
①
90 degree
1. Cold Water line
2. Pipe Clamp.
3. Plastic line
4. Compression Nut
5. Compression Sleeve
6. Packing Nut
8. Filter Cartridge
9. Cartridge Holder
[RF221, RF220]
[RL225]
[RL220]
1 2 3
4
6
5
Control Lever
Flat-blade screw driver(-)
DA68-02659A.indd 1 2012.6.27 12:7:25 PM
To Next Page
Need help?
General
Weight and Dimensions
