setting up
_07
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the fl oor. This surface
should be strong enough to support a fully loaded
refrigerator, or approximately 331lbs (150kg).
To protect the fi nish of the fl ooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working. When
moving the refrigerator, you need to pull and push
it straight forwards or back. Do not wiggle it from
side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench Fastener
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips
screwdriver(+)
Flat-blade screw
driver(-)
Socket wrench
(10mm)
Pliers
Allen wrench
(3/16”) (5mm)
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its fi nal location. Do not remove
the doors/drawer if you don’t need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
Be careful not to drop, damage or t
scratch the door/drawer while removing
them.
Use care when remove the doors/drawer. The t
doors are heavy and you could injure yourself.
Reattach the doors/drawer properly to avoid: t
Moisture from air leakage. -
.tnemngila rood nevenU -
Wasting energy due to improper door seal. -
WARNING
2012.5.16 3:1:41 PM
HOW TO ASSEMBLE THE HANDLE
Fridge door handle assembly
Check the direction of Handle assembly.
(Assemble the side of the handle attached a sticker toward
toward the upper direction.)
01 SETTING UP
To Next Page
Loading...
Need help?
General
Weight and Dimensions
