Setting up your French Door Refrigerator
Remember a level Refrigerator is necessary for getting the doors perfectly even. If you need help, review the
previous section on leveling the Refrigerator.
Setting Up
1. If you open the drawer (
), you can see the lower hinge (
2
).
2. Insert the supplied hex wrench (
3
) into the shaft (
4
) of the lower hinge.
3. Please adjust the height by turning the hex wrench (
3
) clockwise(
) or counter-clockwise( ).
when you turn the hex wrench counter-clockwise( ), the door will move up.
1. After adjusting the doors, please insert the supplied fastener-ring (
5
) using a pair of pliers (
6
) in the
gap between the hinge-grommet (
7
) and the lower hinge(
8
). The number of fastener-rings you’ll need
to insert depends on the gap.
Two fastener-rings are enclosed with the refrigerator.
The thickness of each fastener-ring is 0.04 inch.
When the left
door is lower
than the right
door.
When the left
door is higher
than the right
door.
Adjustment
part
Adjustment
part
3
3
4
2
To Next Page
Loading...
