ASSEMBLE THE FREEZER DRAWER
Pull out the rails fully on each side of the cabinet.
Attach the freezer door front onto the open slots on the sides.
Tighten 4 hex head bolts completely with a socket
wrench(10mm).
Insert the lower basket ( 3 ) into the rail system.
Hook the ends of the tilting pocket ( 1 ) onto the support guards ( 2 )
and push down until they lock into place.
Insert the upper drawer.
Remove 2 pieces of tape ( 4 ) attached to the side of the drawer
bin.
Reattach the tape in the same position when moving the
refrigerator to prevent scratching the drawer bin.
To Next Page
Loading...
